Here is my Decoder. See if you can figure out how to use it-if not, just ask me sometime.

Hopefully this will work. When I uploaded it to Tripod, it did not include an extension (in this case, .zip), so I renamed the file with the .zip extension, and hopefully nothing was lost. In any case, unfortunately, the Zip file is almost 3 megabytes, so it may take around 15-20 minutes (or at least it would on my computer).

Click on this link to download Decoder.zip

After you have saved the file, follow these instructions as best you can.

Instructions:
1. Unzip file to "C:\unzipped\Decoder"
2. Open the folder "C:\unzipped\Decoder"
3. Open the "Package" folder found inside
4. You should see 1 folder and 3 files: the Support folder, "Decoder.CAB," "setup.exe," and "setup.lst"
5. Click on the "setup.exe"
6. Following the instructions and do not change anything (like the install path). If one file is not included, it could crash your computer, but if you leave everything as it is, it should be fine. (Chances are it would be fine if you did change it, but don't, just to be on the safe side.)

The Decoder should now be installed on your computer. Click on the Start menu, go to Programs, then Made by Jason, and click on the Decoder. (If I did everything right-and you did everything right-the file will be installed where I just told you. If it isn't, call me and I'll do my best to help you out.)

Hopefully it all works.
Until next time,
JasonHochreiter@hotmail.com